INNOPUR SHIELD POOL PAINT-2K

INNOPUR SHIELD POOL PAINT-2K

DEFINITION
It is an acrylic polyurethane resin-based, solvent-based, two-component pool paint. It is resistant to ultraviolet rays, abrasion and continuous water contact. It is applied on floors and walls in ornamental pools, ponds, parking lots and garages.

CONSUMPTION
Minimum total consumption: 0.2 -0.4 kg/m2

usage areas
• In pools
• In ponds
• Where mechanical and chemical resistance is required,
• In open atmosphere and industrial structures under the sun,
• It is used where brightness and permanence are required.
• On terraces, balconies and wet floors,
• On concrete or metal surfaces,
• On polyurethane, polyurea and epoxy coated surfaces,
• As a top coat in many outdoor areas, as it is resistant to UV rays,
• It can be used in indoor and outdoor swimming pools.

FEATURES
• It is in liquid form, ready to use.
• It is hard but elastic, does not crack.
• It has high adherence.
• It adheres perfectly even to old coatings.
• It is not harmful to human health.
• It provides resistance to pedestrian traffic with its mechanical resistance.
• Does not soften in summer, does not harden in winter.
• Resistant to water and chemical materials.
• It penetrates the surfaces very well.
• Resistant to severe weather conditions and some chemicals.

APPLICATION
Layers that will reduce adherence such as oil, grease, dirt, paint, cement grout, rust, mold oil, salt bleed should be thoroughly cleaned before application. The surfaces must be clean, sound, free of carrier and free particles. Cracks and fractures on the surface should be carefully repaired with repair mortars and the surface should be prepared. After the surface is ready, primer application should be started. In order for the polyurethane coating to be applied on it to be successful, the pores on the surface must be completely closed. PU PRIMER-1K / EPOXY PRIMER can be preferred as a primer. Application A and B components should be mixed for at least 3-4 minutes until they become homogeneous, preferably with a low-speed mixer, paying attention to the mixing ratios. Ready product should be applied to the primed surface with a roller, brush or spray. The application should be done in at least two coats and 12-24 hours should be waited between the coats. The application area should be protected from water for at least 4-6 hours. It is a two component material. Heating does not require thinning. Gloves must be used during the application. It should not be applied in rainy weather and at temperatures below +5°C.

PACKAGING
A Component: 8 kg + B Component: 2 kg Total: 10 kg set

CLEANING
Tools and equipment should be cleaned with thinner.

SHELF LIFE
It can be stored for at least 12 months in its dry unopened original packaging and at temperatures of 5-25 °C. Once opened, use it as soon as possible. Protect from freezing conditions.

WARNING AND PRECAUTIONS
• The newly applied material should not be exposed to rain and frost for 24 hours.
• It should not be applied below (+)5°C, in rainy and foggy weather.
• Do not apply on wet and frozen surfaces.
• Pay attention to the safety signs and warnings on the packaging.
• Adequate ventilation should be provided in the workshops, open flames and high temperatures should be avoided.
• Mix well before application. Do not leave the lid of the package open.
• Avoid application in weather conditions where precipitation is expected and under precipitation.
• The skin should not come into contact with the eyes and mouth, and the application should be made by taking the necessary safety precautions.